The turn signal holder Frame for Bobber & Bobber Black allow the mounting of all turn signals with M8 thread (Rizoma, Motogadget, Kellerman) on the inside of the frame on your Bobber. Uses the air box bolt, can be used with or without air box delete.
Visually, the turn signals are here as good as no longer noticeable, if you use nice small. From behind they are nevertheless very well visible, since they are higher than the rear wheel & the fender.
In the pictures 3-1 turn signals are installed which combine tail light, brake light & turn signal in one. We then did not install a central tail light on the Bobber. This makes for an extremely tidy tail.
Included with, are 2 black plastic caps that are pushed over the nuts of the turn signals so that they do not stand out.
The holders are made of aluminum and then black powder coated.